Prominence Home 50880, Owner'S Manual, Page: 8 / 12

8
ASSEMBLY INSTRUCTIONS
Light Kit
Hex Nut
Finial Cap
Finial
Bulb
Plastic Spacer
Rubber Washer
Rubber Washer
Plastic Spacer
Hex Nut
Ribbed Bowl
15
14
13
12
12. Remove one of the three fitter plate screws
preassembled to the fitter plate from the round hole
and loosen the other two but do not remove. Connect
the 9-pin connector from the fitter plate to the 9-pin
connector from the light kit.
9-pin
Connector
Light Kit
Fitter Plate Screw
Fitter Plate Screw
Keyhole Slot
13. Align the slotted holes in the light kit with the
loosened screws in the fitter plate. Turn light kit clockwise
and replace the previously removed fitter plate screw.
Tighten all screws.
14. Remove the finial, finial cap, hex nut, plastic spacer
and rubber washer from the threaded rod at the bottom
of the light kit.
Install the three E26-base bulbs into the sockets of the
light kit.
Note
: compatible with any E26-base LED, CFL, or
incandescent bulb (60 watt max.).
15. Lift the ribbed bowl up until the top edge is seated in
the top rim of the light kit. Feed the pull chain through
the rubber washer and plastic spacer and secure with hex
nut.
Note:
The concave side of the plastic spacer will face
downward so that the hex nut will fit inside.