Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · 608-274-4330 · Fax 608-277-2516
13
www.promega.com
TM321 · Revised 4/15
Figure 7. Orientation of Magnetic Rod Assembly.
The orientation of the Magnetic Rod Assembly, with the screw
holes facing the back of the instrument.
Figure 7 shows the correct orientation of the Magnetic Rod Assembly. The screw holes face the back, and the magnetic
rods sit toward the front of the instrument. If the rod assembly needs to be removed for cleaning (see Section 8) and
replaced, ensure that this orientation is retained.
3.
Unpacking and Setting Up the Maxwell
®
16 Forensic Instrument
3.A. Unpacking
1.
Remove the accessory box, power cord and literature package from the shipping container. Slide the instrument
out of the box.
Note:
Do not lift the instrument out of the box by the door handle.
2.
Remove the foam packaging from the sides of the instrument, and remove the clear plastic cover.
3.
Check that all parts are included (Figure 1).
4.
Set the Maxwell
®
16 Forensic Instrument on a flat, level, solid surface in a dust-free location with good air
circulation. If possible, move the instrument back from the edge of the surface to prevent inadvertently bumping
the open door.
!
Important.
Save the packaging material in case the instrument needs to be returned for service or repair later.
9514TB
Back
Front
