Promeba PB-460 Series, User Manual

Page: 23 / 32

USER GUIDE // STRETCHER SUPPORT SERIES PB460 AND PB455
Review 2022/02
23
03
OPERATION
03.3.5 SCOOP STRETCHER FIXATION (ONLY FOR PB460/1, PB460/3 AND PB455)
The PB460/1, PB460/3 and PB455 stretcher supports have accommodation for a scoop stretcher.
Follow the steps below for proper attachment and removal:
To place it, the scoop stretcher must be slid upside down on the base tray. Gently push it until it is in contact
with the front retaining clips. Push it harder against the retaining clips until it is anchored.
To extract the scoop stretcher from the accommodation, hold it with both hands and pull it hard until it
disengages from the clamps. Keep pulling it by sliding it along the base tray until it is completely removed.
03.3.6 SCOOP STRETCHER AND SPINAL BOARD FIXATION (ONLY FOR PB455/4)
The PB455/4 stretcher support has double accommodation for a scoop stretcher and a spinal board.
Follow the steps below for proper attachment and removal:
Take the spinal board together with the scoop stretcher and slide them onto the bed tray. Push them along
the tray until they are in contact with the front stop.
In the central part of the bench you will find a belt that you must fasten around the spinal board and the
scoop stretcher. You will find another belt at the front of the bench that you must pass through the tube of
the scoop stretcher and one of the holes in the spine board and fasten it. Adjust the belts well so that both
products are well secured and thus avoid noise during transport.
To remove the scoop stretcher and the spinal board from the accommodation, unfasten the two belts. Hold
both products together with both hands and pull them out by sliding them along the base tray until they
are completely removed.