Promax PD-185, Instruction Manual

Page: 54 / 60

USER’S MANUAL PD-185
Page 22 11/2015
4.12 Temperature measurements
1. Set the rotary switch in position (
°
C ó
°
F) temperature unit as
required.
2. Connect a type K thermocouple to the thermocouple input
terminal (yellow terminal) on the left hand side of the front
panel.
3. Place the thermocouple junction tip at the point where the
temperature is to be measured.
NOTE:
For very high temperatures the multimeter must be kept far enough
away from the source of temperature to avoid heat damage. At high
temperatures, the life of the temperature probe will be reduced.