10
soft air, cooling time.
●
2
nd
display
○
3 : Second function allows you to adjust time for each given
function of Vacuum, GAS, SEAL1, SEAL2, SOFTAIR, COOLING, and other required parameter
setting .
●
Program number up
○
4 : Program number goes up by pressing
button.
●
Program number down
○
5 : Program number goes down by pressing
button.
●
Increase value
○
6 : Increase any value by pressing
button.
●
Decrease value
○
7 : Decrease any value by pressing
button.
●
Stop vacuum
○
8 : Stop vacuuming and skip to next function by pressing
button.
●
Gas On/Off
○
9 : Switch on or off of gas flushing device by pressing
button.
●
Emergency stop
○
10 : Ends current cycle in process and skip to ventilation.
●
Shift button
○
11
Press hift and Select any function of vacuum, gas, sealing1, sealing2,
soft air, cooling and save the previous setting.
●
○
12 : Turn on the power of control panel by pressing
button.
Note: You must press ON the power of control panel after turning the main power o
●
○
13 Turn off the power of control panel by pressing
switch
Description of each function:
Vac.: To adjust the vacuum time first press shift button to VAC then press
or
to adjust
the desire vacuum, after adjusting press Shift again to save the value.
Note: The vacuum value can be controlled by A. time B. vacuum % plus time delay.(see
description of parameter section)
A. If the number shows “99” means vacuum time by 99 sec.
B. If the number shows”-99” means vacuum by 99 %. After “-99” you can obtain extra
vacuum time to delay by press
button.
Summary of Contents for TC-420
