QUADROTOR LI-POLYMER
LITHIUM BATTERY CHARGING INSTRUCTIONS
Press the battery shortly to switch on, hold for 2 seconds to
switch it off.
Page 5
GPS SHADOW
DRONE
PREPARATION FOR FLIGHT/GPS CALIBRATION
Please choose the spacious indoor or outside environment
for flying, also it requires that it should be flied under the
weather of non- snow or non-storm with wind force less
than Level 4. When flying, please DO keep it far away from
the crowd, tree, electric wire, skyscraper, airport or signal
transmitting tower, etc.
Step 1: Turn on drone and set down on a level surface*
— *The drone will auto-trim to this level surface.
— All lights blinking red
1
Step 2: Turn on remote
— Press Up, then Down on the left joystick
— Lights flashing blue (back) and white (front)
— NOTE: *You can connect to the WiFi at this time to view the current drone status on the
Promark GPS App, or wait until after GPS is calibrated.
2
1. Insert the USB cable into the USB port of a standard 5V wall charger, and then connect with the micro-USB charging port on
the battery. When charging, the indicator on the power blink blue; when fully charged, the indicator will be a solid blue.
2. Full charging time takes about 6 hours, Flight time about 12 minutes.
CAUTIONS WHEN CHARGING:
1. When charging, please put this product in a dry ventilated area and keep it far away from heat sources or flammable
products.
2. When charging, it is recommended to remove the batteries from the quadcopter. Charging process should be supervised by
an adult so as not to cause an accident. The battery can also be charged while in the quadcopter.
3. After flying, please do not charge the battery if the surface temperature is still warm. If the battery has been used for a long
time, or appears to be swollen, please replace them.
4. Please make sure that you use the original USB charging cable provided.
5. Any battery, when not in use for a long time, will lose its charge automatically. Charging or discharging too often may
reduce the life of the battery.
DISCLAIMER: You must use the original USB cable and standard 5V wall charger.
WARNING: Never charge with an input stronger than 5V. This can cause the battery to overheat.
