Promaker PRO-SC800, User Manual

Page: 6 / 24

6
CUTTING ANGLE ADJUSTMENT
For cutting of mitre angles loosen the
2 set screws till the saw shoe to the
required mitre angle. Mitre angle to
the left/right is maximum 45°. After
adjusting desired angle, tighten the
set screws firmly. Adjustable angles
on jigsaw are 0°, 15°, 30°, 45°.
PLUNGE SAWING
Only soft materials such as wood,
aerated concrete, plaster board
aerated concrete, plaster board, etc.
may be worked with plunge method.
Cut-outs in wood are possible without
predrilling by piercing with the running
machine. This is requires a certain
amount of practice, however, and is
possible only wit short saw blades.
Place the front edge of the base plate
on the workpiece and switch on.
Press the machine firmly against the
workpiece and plunge the saw blade
slowly into the workpiece.
After reaching the required cutting
depth, bring the machine again to the
normal working position so that the
complete surface of the base plate
rests on the workpiece and continue
to saw along the cutting line.
After completing the cut, switch off the
machine first and then pull it out of the
cut.
MAINTENANCE AND CLEANING
Before any work on the machine itself,
pull the mains plug.
Guide roller should occasionally be
checked for wear and lubricated with
a drop of oil. If it is worn , it must be
changed. For safe and proper working,
always keep the machine and the
ventilation slots clean.
If the machine should happen to fail
despite the care taken in manufacture
and testing, repair should be carried
out by an authorized customer
services agent for PROMAKER
®
tools.