Promaker PRO-PC1200, User Manual

Page: 7 / 32

7
16. At the end of each work session,
place the paint chips and dust in a
double plastic bag. Close the bag
with a twist tie and dispose of it in
accordance with local regulations.
17. Remove protective clothing
and shoes in the work area to avoid
transferring dust into other areas
of the building. Wash work clothes
separately using a high quality
detergent. Wipe shoes off with wet rag
and then wash the rag with the work
clothes or dispose of it in the bag of
dust and debris.
18. Do not use the Heat Gun in the
presence of flammable liquids or
gases.
19. Do not use the Heat Gun near
combustible materials such as dry
grass, leaves or paper, which can
catch fire.
20. Do not lay the Heat Gun on a
flammable surface during operation or
immediately after turning it OFF. The
nozzle becomes very hot. Always set
the Heat Gun on a flat level surface
so the nozzle is directed upward and
away from the supporting surface.
21. Keep the Heat Gun in constant
motion. Do not stop or dwell in one
spot.
22. Never touch the nozzle immediately
after use. It will be very hot and can
cause severe burns.
23. Never use the Heat Gun as a hair
dryer. The extreme heat will burn your
scalp and scorch your hair.
24. Always use gloves while operating
the Heat Gun. Tools and scrapings
become very hot.
25. Always treat the Heat Gun with
the same respect as an open flame.
It can burn you and cause a fire if
not handled and used with extreme
caution.
WARNING
EXPLOSION OR FIRE HAZARD:
This heat gun produces extremely
high temperatures which can reach
up to 842° F (450° C). Use extreme
caution to prevent combustible
materials from igniting. Never use the
heat gun near volatile liquids such as
cleaning solvents, lacquers, gasoline,
etc.
Never operate the Heat Gun if the
blower motor does not turn ON. Turn
the Heat Gun OFF immediately.
Operating the Heat Gun without the
blower motor running will burn the
element out.
EXTENSION CORD SAFETY
WARNING
1. Keep the extension cord clear of the
work area. Position the cord so that it
will not get caught on the workpiece, a
tool, or any other obstruction while the
power tool is in use.
2. If an extension cord is used with
this heat gun, verify that it is in good
condition. When using an extension
cord, be sure to use one that is heavy
enough to carry the current that the