Promaker PRO-ES2000, User Manual

Page: 11 / 32

11
The protective cover can be turned
to a desired angle, but not more than
45° on left side or right side.
CAUTION:
Please use Protective Cover (6) for
grinding disc.
Please use Protective Cover (12) for
cutting disc.
Grinding and Surface Processing
In order to grind surface, you should
use a coarse abrasive disk with a
sunken centre.
You can use the abrasive disks with
diameter of 180mm. The maximum
thickness of
disks is 6mm.
Cutting metal
In order to cut rods, tubes and metal
parts you should use a cutting-off
wheels with diameter of 180mm.
The maximum thickness of wheels
In this case is 3mm.
Cutting Stone Material
When cutting stone material you
should use the cutting-off wheels
with diameter of 180mm. The
maximum thickness of wheels in
this case is 3mm.
Please use proper wheels to work.
Failure to use the right cover for
operation could result in injury.
WARNING! Cutting operations with
abrasive cutting-off wheels are only
allowed when a cut-off guard.
Always approach the job at the same
angle at which you would like to cut.
Maintain this angle during cutting
and do not exert any side pressure
on the wheel.
Mounting the Wheels /Disks
Please proceed as follows when
mounting the wheel/disk
1. Before mounting, remove the
mains plug from the socket! Ensure
that the protective device is correctly
installed.
2. Place the internal flange (10) on
the drive shaft (2). Ensure that it is in
contact with the two flat areas.
3. Place the abrasive disks /wheels
on the drive shaft (2). Ensure that it
is correctly in place.
4. Now screw the external flange (9)
to the drive shaft (2), Ensure that it