1-5.
Items Needed for Set Up
1.The downfeed handles must be installed to operate the drill press.
To install the downfeed handles:
Thread the handles into the spindle hub, as shown in
Figure 02
, and tighten.
2.Install the crank lever over the pinion shaft, and tighten the setscrew in the crank handle against the
flat part of the pinion shaft.
Figure 03,
3. The drill chuck attaches to the spindle by means of the arbor, shown in
Figure 04
. Matched tapers
onThe arbor and the inside of the chuck create a semi-permanent assembly when properly joined.
Figure 02
Spindle Hub
Wrench
handle
Figure 03
Flat part
6
Summary of Contents for 930ELB
Page 20: ...7 CIRCUIT DIAGRAM 20...
