17
6. Refer to picture below when performing assembling handle sections. Press Quick Disconnect on handle
piece 2, this will allow slide handle pieces 1 and 2 to connect, align the holes on both sections to allow quick
disconnect to trigger. Quick disconnect will automatically pop out when hole position is correct.
7. Unfasten the screw located in the Handle Socket to insert the assembled handle.
8. Line up the square hole located at the bottom of the handle over the square bolt inside the Handle Socket.
9. Secure the handle in place by tightening the screw in the handle socket without any vehicle on the jack. Cyc-
le the lift up and down several times to insure the hydraulic system is operating properly. (Perform the System
Air Purge Procedure before fi rst use.)
WARNING: Do not lift or carry the jack by the handle. Handle could dislodge and jack may fall, resulting in
possible injury or property damage.
System air purge procedure
WICHTIG: VOR DER ERSTEN ANWENDUNG
Perform the following System Air Purge Procedure to remove any air that may have been introduced into
the hydraulic system as a result of product shipment and handling. This step is to be completed without any
weight on the jack.
Handle
PC. 2
Quick
Disconnect
Handle Socket Screw
Handle
PC. 1
English
Original operating instruction - 2.5 ton aluminium steel service jack
