5
English
Alarm
Setting the alarm
1. Press [MODE] once. “AL” and the hours and the minutes display will all be shown.
2. Hold down [SET] for a few seconds until the hours display begins to flash.
3. Set the hours with [
▼
] and [
▲
] and confirm with [SET].
4. The minutes display will start to flash. Set the minutes with [
▼
] and [
▲
] and
confirm with [SET].
Activating/deactivating the alarm
1. Press [MODE] to show the set alarm time. “AL” will be displayed.
2. Press [SET] to activate the alarm ( will be displayed in the upper right corner).
Push again to deactivate the alarm ( will not be displayed).
3. The alarm is programmed to sound for approximately two minutes.
Snooze function
To activate snooze once the alarm has sounded press [SNOOZE/LIGHT].
The alarm will then sound again after five 5 minutes.
Temperature, relative humidity and
weather forecast display
Indoor temperature and relative humidity display
• The actual temperature from 0 to +50 °C will be displayed. If the reading is outside
this range “LLL” will be shown.
• Switch between display in °C and °F by pressing [
▲
].
• Switch between current, min or max temperature display by pressing [MAX/MIN].
Relative humidity range: 20 to 99 % RH. If the reading is outside this range “LL”
will be shown.
Forecast display
Forecasts shown as 3D icons:
•
(sunny)
•
(intermittent sunshine)
•
(cloudy)
•
(rain)
Note:
It takes at least one day before the collected weather data can provide a stable
weather forecast. The weather icons will flash whenever the weather data is updated.
