Proline PMC57W-F, Usage And Installation Manual

Page: 17 / 133

4. USE OF YOUR PRODUCT
15
4.1.1
Cooktop have 3 positions: Off ( ), max (big flame symbol) and min (small flame
symbol). After igniting the burner position, you can adjust the flame length between
"Max" and "Min" positions. Do not put the control knob between the "Max” and “Off” positions.
Using cooktop burners
control knobs
at "MAX"
After the ignition, check the flames visually. If you see
yellow tip, lifted or unstable flames; turn the gas flow off,
and check the position of burner caps and crowns (fig.16).
Take note: these elements are very hot, let them cool to avoid
burning yourself. Be careful that no liquid flows inside the
burners. If the flames accidentally escape from the burner,
ventilate the kitchen with
fresh air, and wait at least 90 seconds before re-igniting.
To stop the cooking, turn the control knob clockwise until the
mark on the control knob is facing the point " "
turn the control knob to OFF ( )
Your cooktop is fitted with burners of different diameters.
The cheapest way to use the
gas is to reduce the flame to minimum position once you reach boiling point. It is recommended
to always cover your cooking pan.
Rapid Burner: 22-26cm
Semi-rapid burner 14-22cm
Auxiliary burner: 12-18cm
In order to obtain the most efficiency
from the cooker, pay attention to the sizes of saucepans that you put
saucepans have flat bases. Do not use saucepans with concave or convex bases to avoid
wasting energy. Use proper-sized saucepans corresponding to the flame; if you use containers
smaller than those specified below, you will have wasted energy.
on the cooker and make
sure
MAX Position
Off Position
Intermediate MIN Position
Figure 15
Cap
Crown
Burner
Figure 16
Low
Thermocouple
Downloaded from www.vandenborre.be