Proline LD1922D2, Operating Instructions Manual

Page: 12 / 65

English - 11 -
Inserting Batteries into the
Remote Control Handset
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the remote observing
the polarity markings inside the battery compartment
then replace the battery cover.
Note: Remove the battery from remote control handset when
it is not to be used for a long period. Otherwise it can be
damaged due to corrosive leakage of the batteries invalidating
the warranty.
Switching the TV On/Off
To Switch the TV On
• Connect the power cord to the 220-240V AC ,50 Hz.
Then the standby LED lights up.
• To switch on the TV from standby mode either:
• Press the “ ” button, P+ / P- or a numeric button
on the remote control.
• Press the “ ” button, -P/CH or P/CH+ button on
the TV. The TV will then switch on.
Note : If you switch on your TV via PROGRAMME UP/DOWN
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
• Press the “ ” button on the remote control or press
the “ ” switch on the TV, so the TV will switch to
standby mode.
Note : If you have switched off the TV set from the standby
button on the TV, next time you press the standby button, the
TV set will switch on without going to the standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources.
• Press “ /SOURCE ” button on your remote control
for directly changing sources.
or
• Select “ Source ” option from the TV Setup option in the
main menu by using “ ” or “ ” button. Use then “ ” or
“ ” button to highlight an input and press “ ” button
to select.
Note : You can mark desired source options by pressing the
OK button. Therefore, when
“ /SOURCE ”
button is
pressed, only the marked source options will be available
(except for the TV source).
Note : YPbPr mode can be use only when you connect a
device that has a YPbPr output through the PC input with
YPbPr to PC cable (YPbPr cable is not supplied).
Basic Operations
You can operate your TV using both the remote
control and onset buttons.
Operation with the Buttons on the TV
Main menu OSD cannot be displayed via control
buttons. “
+/- ” buttons will function as volume up/down
as default. Even if you set other functions for these
buttons, “
+/- ” buttons will perform as default after a
short while.
Volume Setting
• Press “ P/V/AV ” button once and then use “ +/- ” buttons
to increase or decrease volume, so a volume level
scale (slider) will be displayed on the screen.
Programme Selection
• Press “ +/- ” to select the next or previous programme.
AV Mode
• Hold the “ P/V/AV ” button, source OSD will be
displayed.
Operation with the Remote Control
• The remote control of your TV is designed to control
all the functions of the TV. The functions will be
described in accordance with the menu system of
your TV.
A01_[GB]_MB45_1055UK_PANEUIDTV_BRONZE11_19822_10065707_50156721.indd 11 A01_[GB]_MB45_1055UK_PANEUIDTV_BRONZE11_19822_10065707_50156721.indd 11 27.10.2009 16:58:59 27.10.2009 16:58:59