TRIPLESCAN
8
3.4 Operation in automatic mode
if no DMX control signal is present at the DMX input, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
•
Press the button MODE until appears on the display [
AUTO
].
•
Press the button SETUP to select programs [
n.001 - n.100
] with the buttons UP and DOWN.
•
Press the button SETUP to select the speed of execution [
SP01 -SP99-SPFL
] with the buttons UP and DOWN.
•
Press the button SETUP to select the flash frequency [
FS01 - FS99
] with the buttons UP and DOWN.
3.5 Programs
To select the preset programs:
•
Press the button MODE until appears on the display [
Pr01
].
•
Press the buttons UP and DOWN to select the programs [
Pr01 - Pr15
].
•
Press the button SETUP to select the speed execution [
SP01 - SP99 - SPFL
] with the buttons UP and DOWN.
•
Press the button SETUP to select the flash frequency [
FS01 - FS99
] with the buttons UP and DOWN.
3.6 Sound mode
•
To enter in sound mode; press button MODE until appears on the display [
SOUN
]
•
Press the button SETUP to select t [
S1.00 - S1.31
] with the buttons UP and DOWN.
3.7 Master/Slave mode
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave (
SLAV
) with the same effect.
•
Press the button MODE until appears on the display [
SLAV
].
•
Select the desired program (see section 3.4).
•
Use standar DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For the longer cable runs we suggest a terminator at the last fixture (see page 9).
3.8 DMX mode
•
Press the button MODE until appears on the display [
d.001
]
•
Press the buttons UP and DOWN to select the value desidered (
001-512
)
•
Press the button SETUP to select the different mode DMX [
dp1 - dp2
] with the buttons UP and DOWN.
The tables on page 12 indicate the operating mode and DMX value
3.9 DMX addressing
To able to operate the TRIPLESCAN with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX chan-
nel, adjust the start address 33 on the TRIPLESCAN. The other functions of the light effect panel are then
automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
3
33
33-35
36
39
42
4
33
33-36
37
41
45
Summary of Contents for TRIPLESCAN
