ProLights TRIPLESCAN, User Manual

Page: 19 / 32

5
TRIPLESCAN
Fig.2
8
7
1.2 Description and technical specifications
Compact and powerful lighting effect composed by three dynamic scanners based on RGBW LED technol-
ogy.
• Light source: 12x3W RGBWA LEDs (3 red, 3 green, 3 blue, 3 white).
• Effect type: multicoloured dynamic beams with reproduction of overlapping shapes and dynamic ani-
mation.
• LED average life span: >50’000 hours
• Control panel and user interface through 4 char LED display.
• Auto mode: 15 built-in programs selectable from display, execution speed and strobe adjustment.
• DMX mode: 2 DMX modes available, 3 and 4 channels for remote controlling of auto shows, Sound mode
activation and colours selection.
• Master/Slave mode: for synchronized operation of more units linked in a chain.
• Sound mode: sound activation through built-in microphone and sensitivity control.
• Connections: XLR-3p (signal), VDE socket (power).
• Hanging system: adjustable aluminium bracket.
• Power supply: AC 100/240V, 50/60Hz
• Power consumption: 45W
• Weight: 4,5kg
• Dimensions (WxHxD): 384x295x209 mm
- 2 - INSTALLATION
2.1 Mounting
TRIPLESCAN can be fixed (as shown below) using the mounting bracket screws or using the dedicated light-
ing support if mounted on a crossbeam. To align the light effect unit, release the locking screws (fig.2); ad-
just the desired inclination of the unit, then retighten the screws. The mounting place must be of sufficient
stability and be able to support a weight of 10 times of the unit’s weight. When carrying out any installation,
always comply scrupulously with all the regulations (particularly regarding safety) currently in force in the
country in which the fixture’s being used.
• Install the projector at a suitable location by means of the mounting bracket (7).
• Always additionally secure the projector with the safety rope from falling down. For this purpose, fasten
the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.
• Adjust the projector and use the knob (8) to slightly release or tighten the locking mechanism of the
bracket if is necessary.