SLASH
20
3.11 PERSONALITY
1. Press the MODE button to enter the main menu and scroll using UP/DOWN button to select
PERSONALITY
,
and then press ENTER button.
2. Use UP/DOWN button to select:
STATUS SETTING - FANS CONTROL - DISPLAY SET - TEMPERATURE C/F - RESET DEFAULT
.
3. Press ENTER button to confirm the selection.
4. Press the MODE button to go back or to meet the waiting time to exit from the setup menu automati-
cally.
Status setting -
[STATUS SETTING]
-
•
In
STATUS SETTING
mode the parameters described below can be changed:
-
ADDR VIA DMX
- DMX addressing via external controller. Select
ON
or
OFF
if want, respectively, en-
able or disable the function.
-
NO DMX STATUS
- Control in case of DMX signal errors. Select
CLOSE
to activate the blackout mode;
select
HOLD
to maintain the current setting or select
AUTO
or
MUSIC
mode to set the operation
mode in case of error signal DMX.
-
PAN REVERSE
- Reverse PAN movement. Select
ON/OFF
for normal/inverted control of the PAN func-
tion.
-
TILT REVERSE
- Reverse TILT movement. Select
ON/OFF
for normal/inverted control of the TILT func-
tion.
-
FINE RESOLUTION
- Configuration DMX channels. Select
ON
to set MODE1 configuration or select
OFF
to set MODE2 configuration.
-
WDMX
- Wireless control. To control the wireless receiver unit to refer to status of LED indicator (4):
•
Red LED: the wireless receiver is not configured with the transmitter. So, use “Reset” wireless.
•
Fast flashing red LED: no wireless signal
•
Slow flashing red LED: wireless signal.
•
Green LED: signal wireless and DMX. The wireless receiver is configured with the transmitter.
Select
ALONE
if you use the SLASH as a single unit; select
MASTER
to transmit the DMX signal to the
units connected. Choose
OFF
to disable the wireless control or select
RESET
to reset the function.
NOTE - The fixture must be reset before it can be paired with a new WDMX transmitter.
-
MIC SENSITIVITY
- Microphone sensitivity. Select this function to set the microphone sensitivity (
0-
99%
) for control via music mode. The default value is set to
70%.
Fans control -
[FANS CONTROL]
-
•
In
FANS CONTROL
mode you can choose the speed rotation of the fans. Use UP/DOWN button to
select
AUTO FANS SPEED - HIGH FAN SPEED - LOW FANS SPEED
.
Display setting -
[DISPLAY SET]
-
•
In
DISPLAY SET
mode you can set the display off after an interval of time. Select the desired value of
2
and
59 minutes
.
Temperature C/F -
[TEMPERATURE C/F]
-
•
In
TEMPERATURE C/F
mode you can set temperature unit: use UP/DOWN button to select
Celsius degree/
Fahrenheit degree
.
Reset Default -
[RESET DEFAULT]
-
•
Select
RESET DEFAULT
to reset the default values.
