ProLights PIXIEZOOM, User Manual

Page: 17 / 40

PIXIEZOOM
15
3.20 FAN MODE
To set the rotation speed of the fans refer to the following guide:
• Press the MENU key repeatedly until the display shows Fan Mode , then press the button ENTER.
• Select by pressing UP/DOWN one of the following options: Auto - High . It is possible choose the speed of
rotation of the fans from: fast High and automatic Auto .
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
3.21 WHITE BALANCE
Enter the White balance to adjust the Red , Green , Blue and White parameter to make different whites.
• Press the button MENU so many times until shows
White Balance
, and press the button ENTER to confirm.
• Select the color R, G, B, W through the buttons UP/DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 125 - 255 .
• Press ENTER button to continue to the next color R, G, B, W .
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.22 KEY LOCK
Enter the Key Lock mode to select whether the access password is on or off.
• Press the button MODE so many times until show
Key Lock
and press the button ENTER to confirm.
• Use UP/DOWN button to select: ON or OFF .
• Press ENTER button to confirm the selection.
When the fixture is set as pass ON, after 30 seconds or turn on the fixture next time, the fixture will need
an access password to enter the display menu control.
NOTE - The factory access password is
UP + DOWN + UP + DOWN
(press ENTER to confirm the access).
3.23 RDM - Remote Device Management
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for “Remote Device Management” and makes remote control of
devices connected to the DMX-bus possible. Manual settings like adjusting the DMX starting address are
no longer needed. This is especially useful when the device is installed in a remote area. RDM is integrated
in DMX without influencing the connections. The RDM-data is transmitted via the standard XLR-poles 1
and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be operated
in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not influence
conventional devices. If DMX splitters are used and RDM control is to be used, these splitters must sup-
port RDM. The number and type of RDM parameters depend on the RDM controller (not included) is used.