ProLights PIXIEZOOM, User Manual

Page: 12 / 40

10
PIXIEZOOM
3.5 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the MENU button so many times until the display shows Static , then press the ENTER button.
• Select Fixed Color through the UP/DOWN buttons, then press ENTER.
• Set the colors
R , G , B, W, GB, RB, RG, RGB, RW, GW, BW, RGW, RBW, GBW, RGBW
through the UP/DOWN buttons,
then press ENTER.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.6 WHITE PRESETS MODE
The white presets mode allow you to choose a preprogrammed white color temperature.
• Press the MENU button so many times until the display shows Static , then press the ENTER button.
• Select White Presets through the UP/DOWN buttons, then press ENTER.
• Choose the white color temperature through the UP/DOWN buttons, then press ENTER.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.7 MANUAL MODE
This mode allows to combine the colors red, green, blue and white (R, G, B, W) .
• Press the MENU button so many times until the display shows
Static
, then press ENTER.
• Select Manual Color through the UP/DOWN buttons, then press ENTER.
• Select the color R, G, B, W through the UP/DOWN buttons, then press ENTER.
• Using UP/DOWN buttons, select the desired color value 000 - 255 .
• Press ENTER button to continue to the next color R, G, B,W .
• Continue until the desired mix is obtained.
• Press the button MENU to go back or to meet the waiting time to exit the setup menu.
3.8 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Press the MENU button so many times until the display shows Master/Slave , then press ENTER.
• Using UP/DOWN buttons, select the desired mode and then press ENTER.
• Press the button MENU to go back or to meet the waiting time to exit the setup menu
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Set on master fixture the desired program (see section 3.4).
• Set the slaves to the same DMX modes.
3.9 LINKING
1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.