ProLights M200LED, User Manual

Page: 28 / 36

M200LED
12
3.12 Remote control EC800 (optional)
The remote control EC800 (fig. 2) available as an accessory allows to control different functions.
1. Connect the remote control to the jack ONLY FOR REMOTE CONTROL (10).
2. No DMX signal must be present at the DMX INPUT (11). The LED MASTER (5) must light up.
3. Via the DMX OUTPUT (12), it is possible to connect further units in order to control them via the remote
control together with the master unit.
4. With the button STAND BY (15), the sleep mode can be switched on and off. With the sleep mode
switched on, the LED next to the button will light up. The pan head will go to its starting position and the
light beam will be switched off.
5. With the button MODE (17), select the operating mode:
a) SOUND mode (LED next to the button MODE does not light up).
Each time the button FUNCTION (16) is kept pressed, the unit changes to the next of the three strobo -
scopic effects:
- Stroboscope independent of the music, in sync with the slave units;
- Stroboscope independent of the music, alternating with the slave units;
- Stroboscope depending on the music.
b) SHOW mode (LED flashing).
Select the desired show programme (Show 1 to 4) with the button FUNCTION (16).
c) How to choose color and gobo (LED lights continuosly).
- Press to select color;
- Hold to select gobo.
Note. The length of the cable remote EC800 is 10 m.
- 4 - MAINTENANCE
4.1 Cleaning the unit and maintenance
• Make sure the area below the installation place is free from unwanted persons during set-up.
• Switch off the unit, unplug the main cable and wait until the unit has cooled down.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
• Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any
deformation.
• When the lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• In order to protect the device from overheating the cooling fans (if any), and ventilation openings should
be cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• It is recommended to clean the plastic panel of the unit at regular intervals, from impurities caused by
dust, smoke, or other particles to ensure that the light is radiated at maximum brightness. For cleaning,
disconnect the main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then
carefully wipe the plastic pane dry. For cleaning other housing parts use only a soft, clean cloth. Never
use a liquid, it might penetrate the unit and cause damage to it.
Warning: we strongly recommend internal cleaning to be carried out by qualified personnel!