ProLights M200LED, User Manual

Page: 22 / 36

M200LED
6
3.1 Operation
Connect the plug of the mains cable to a socket (230 V~/50 Hz). Thus, the unit is switched on. The pan head
and all control motors go to a defined starting position. Then the unit is ready for operation and can be
operated via a DMX controller or independently displays its show programme in succession. To switch off,
disconnect the mains plug from the socket. For a more convenient operation it is recommend to connect
the unit to a socket which can be switched on and off via a light switch.
3.2 Basic adjustments
Via a menu the following basic adjustmentscan be made. Press the button MENU (2) so many times until
the desired function is shown in the display (1). Then press the button ENTER (4). Never wait for more than
8 seconds to press the next button, otherwise the adjusting procedure will be stopped.
- 3 - FUNCTIONS AND SETTINGS
Adjustment of the start address:
Addr
. . .
1
512
Show mode: show 1
show 4
ShMd
. . .
Sh 1
Sh 4
Slave mode:
2 light show
normal
SlMd
. . .
Sl 1
Sl 2
Sound mode: on
off
SOUn on
oFF
Blackout mode on or off
The light beam is not extinguished. This adjustment must be
selected when operating without DMX controller.
The light beam is extinguished when no DMX control signal
is present at the jack DMX IN (11). As soon as corresponding
DMX signals are present, the light beam will be released.
To memorize, press ENTER button.
Select with DOWN or UP botton (3):
blMd
no
YES
Pan motion of the pan head: normal
opposite panning
I PAn no
I
Tilt motion of the pan head: normal
opposite movement
I tLt no
I