ProLights LUMIPAR18VWPRO, User Manual

Page: 28 / 40

LUMIPAR18VWPRO
10
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.8 DMX CONFIGURATION
LUMIPAR18VWPRO is equipped with different DMX configuration.
• Press the button MENU so many times until shows
[CHANNEL]
, and press the button ENTER to confirm.
• Select the desired DMX configuration ( 2CH - 3CH - 7CH ) through the buttons UP/DOWN.
The tables on page 12 indicate the operating mode and DMX value. The LUMIPAR18VWPRO is equipped
with 3-pole XLR connections.
3.9 DMX MODE
• Press the button MENU so many times until the display shows [ADDRESS] , and press the button ENTER
to confirm.
• Press UP/DOWN button to select the desired value ( 001-512 ). Press and hold to scroll quickly.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
To able to operate the LUMIPAR18VWPRO with a light controller, adjust the DMX start address for the
first a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first
DMX channel, adjust the start address 33 on the LUMIPAR18VWPRO. The other functions of the light effect
panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
DMX512 Controller
DMX Address: 33 DMX Address: 54 DMX Address: 40 DMX Address: 47
. . . . . . . . . . . .
Example 7 DMX channels configuration
Fig.5
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
7 33 33-39 40 47 54