ProLights Lumipar 12UTRI, User Manual

Page: 32 / 40

LUMipAR12UTRi
14
3.15 OPERATION THROUGH THE IRC CONTROLLER
To control the LUMIPAR12UTRI with the infrared remote control:
• Press the button MENU repeatedly until SET , then press button ENTER to confirm.
• Using UP/DOWN button to select On or Off to enable or disable the infrared remote control.
• Press the button ENTER to confirm the chose.
NOTE - Make sure to point the controller directly at the receiver on the product.
Automatic Mode
Automatic Mode will enable you to run the automatic programs on the
product.
To turn on Automatic Mode:
1. Press AUTO on the controller.
2. Press + or – to choose between the different auto programs.
To adjust the speed of the automatic program:
1. Press SPEED on the controller.
2. Press %.
3. Press + or – to either increase or decrease the speed of the program.
Sound Active Mode
Sound Active Mode will enable the product to respond to the music.
To turn on Sound Active mode:
1. Press SOUND on the controller.
To adjust sound sensitivity in Sound Active mode:
1. Press SENSITIVITY on the controller.
2. Press %.
3. Press + or – to either increase or decrease sound sensitivity.
Manual Color Control
To choose a specific color with the controller:
1. Press MANUAL on the controller.
2. Press any number between 0-9 to choose your color.
To manually control the RGB percentage:
3. Press MANUAL on the controller.
4. Press R, G, or B to choose your color.
5. Press + or – to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the strobe rate of the program:
1. Press STROBE on the controller.
2. Press + or – to increase or decrease the strobe rate.
3. Press STROBE again to turn off the strobe.
To change the switching effect of the program:
• Press FADE/SNAP on the controller.
• Fade will slowly switch the effect. Snap will rapidly switch the effect.
To black out the lights:
• Press BLACK OUT on the controller.
• This will turn off all the lights until the button is pressed again.
NOTE - The controller will not respond to any inputs when Black Out is activated. If the remote does not
respond when a button is pressed, try pressing BLACK OUT. You may have inadvertently activated BLACK
OUT.
Fig.8
IRC REMOTE
BLACK
OUT
AUTO
STROBE SPEED
SOUND
SENSI-
TIVITY
%
MANUAL FADE
R G B
+
0
1 2 3
4
5 6
7 8 9
A UV W