ProLights LDID 180, User Manual, Page: 25 / 32

GB
LDID180
www.prolights.it info@prolights.it
9
» FUNCTIONS AND SETTINGS
By LED display panel
1. Each fixture needs to have an address setting to receive the data sent from the controller. The address
number is between 0-511 (usually 0 & 1 are equal to 1). The address, also know as the start channel, is
the first channel used to receive instructions the controller.
2. The fixture uses six channels. (Fixture 1 = 1, Fixture 2 = 7, Fixture 3 = 13, Fixture 4 = 19, Fixture…).
3. No need to turn the fixture off when you change the DMX address, as new DMX address setting will
be effected at once. Every time you turn the fixture on, it will be ready to receive DMX signal or run the
built-in programs.
Universal control DMX
Once the control signals of the DMX controller are received, the red LED DMX (9) lights up and the display
shows the start address. The light effect panel can now be operated with the DMX controller.
Important for DMX control via 6, 9, 15 or 27 channels (not for 24 channels):
For RGB control (direct control of the red, green and blue LEDs) adjust DMX channel 1 to 0-28 and DMX
channel 2 to 0-15.
The show programme nos. 1-9 are switched on via DMX channel 1 from a value of 29 onwards and their
running speed or the music control is then adjusted via DMX channel 2.
For the color transition programme adjust DMX channel 1 to 0-28 and DMX channel 2 for the transition
speed to 16-255.
Remote control EC800 (optional)
The remote control EC800 (fig. 2) available as an accessory allows to control different functions:
4. Connect the remote control to the jack ONLY FOR REMOTE CONTROL (6).
5. No DMX signal must be present at the DMX INPUT (8).
6. At DMX (7) can be connected to other movements LDID180 remote synchronized with the main unit.
7. With the STAND BY button (17) you can activate and deactivate the light rays. If the feature is turned off for a
check, the LED next to the button lights up.
8. With the MODE button (19), select the operating mode:
a) Stroboscope mode SOUND (LED next to the MODE button does not light up).
Each time the FUNCTION button (18) is kept pressed, the unit changes to the next of the three stroboscopic
effects:
- Stroboscopic effect permanent;
- Strobe effect 2 LIGHT SHOW;
- Stroboscopic effect depends on the music.
b) Show mode (LED flashing).
With the FUNCTION button (18) you can change between 8 levels, the speed of rotation. With each press of
the button simultaneously changes the direction of rotation.
N.B. The length of the cable remote EC800 is 10 m.