19
hALURoCK
3.9 MOTOR SETTING
• Press the button MENU to enter the menu mode. Use the buttons UP/DOWN to select the
Motor Setup
item. Press the button ENTER to confirm.
• Select the desired parameter using the UP/DOWN button and press the ENTER button to confirm the
setting.
-
Pan Inverse
- Used for reversing Pan movement. Select
Pan Inverse
, press ENTER button to confirm,
present mode will blink on the display, use UP/DOWN button to select
No
(normal) or
Yes
(pan
inverse), press ENTER button to store.
-
Tilt Inverse -
Used for reversing tilt movement. Select
Tilt Inverse
, press ENTER button to confirm, present
mode will blink on the display, use UP/DOWN button to select
No
(normal) or
Yes
(tilt inverse), press
ENTER button to store.
-
Motor Offset
- Allows you to set an offset for the pan/tilt motor.
Pan
Offset
set an offset for the pan
motor,
Tilt
Offset
set an offset for the tilt motor.
• Press MENU button back to the last menu or let the unit idle one minute to exit menu mode.
3.10 PROTOCOL SETTING
To set the protocol to be used for the unit refer to the following section of the menu.
• Press the button MENU to enter the menu mode. Use the buttons UP/DOWN to select the
Protocol Setup
item. Press the button ENTER to confirm.
• Select the desired parameter using the UP/DOWN button and press the ENTER button to confirm the
setting.
-
Only DMX
- Selecting this option is set the DMX as communication protocol. So DMX inputs and
outputs will be enabled and ArtNet inputs and outputs will be disabled.
-
Only ArtNet
- Selecting this option is set the ArtNet as communication protocol. So ArtNet inputs and
outputs will be enabled and DMX inputs and outputs will be disabled.
-
DMX
- Selecting this option are set ArtNet and DMX as communication protocols. So all inputs
and outputs are enabled.
-
Kl DMX
- Selecting this option are set KlingNet and DMX as communication protocols. So all
inputs and outputs are enabled.
• Press MENU button back to the last menu or let the unit idle one minute to exit menu mode.
3.11 ARTNET SETTING
It is possible to change the ArtNet setting in the following way:
• Press the button MENU to enter the menu mode. Use the buttons UP/DOWN to select the
ArtNet Setup
item. Press the button ENTER to confirm.
• Press the button UP/DOWN to select
IP Mode, Net, Subnet, Universe, Start Channel
. Then press the button
ENTER.
• Set the value of parameter, through the button UP/DOWN and press the button ENTER to confirm.
• Press MENU button back to the last menu or let the unit idle one minute to exit menu mode.
3.12 DISPLAY SETTING
• Press the button MENU to enter the menu mode. Use the buttons UP/DOWN to select the
Display Setup
item. Press the button ENTER to confirm.
• Select the desired parameter using the UP/DOWN button and press the ENTER button to confirm the
setting.
-
Back Light
- Display backlight. Select
Back Light
, press ENTER button to confirm. Use the UP/DOWN
keys to select
On
for display always on or
Off
for setting display off one minute after the exit from the
Summary of Contents for Halurock
