EXPLO3000D
12
•
Set DIP switch pin 10 to OFF for normally off operation, or to ON for normally on.
3.8 REMOTE CONTROLLER
This section describes how to operate the EXPLO3000D with optional remote controls.
•
When connected to the remote control ECS448, the EXPLO3000D flashes with controlled chase and
intensity when the Strobe button is pressed on the ECS448.
•
Pin 2 on the Mode DIP switch ON to choose ECS448 function.
*
**
***
Blinder effect
Invert switch On/ Off
Turn on the switch 6 (Low Power)
for long life lamp hour
Fig.7
1
2
4
8
16
32
64
128
* *
* * *
*
3.7 STAND-ALONE OPERATION
This section describes how to operate the EXPLO3000D in stand-alone mode without a DMX controller.
•
Apply power to the fixture.
•
Set pin 1 of the Mode DIP switch to ON. Set pins 2 - 5 to OFF. Set pin 6 to ON for low-power operation
or to OFF for high-power operation.
•
Select either a flash rate or the blinder effect. You set a flash rate by setting the value with pins 1 - 8 of
the Address DIP switch. (See below drawing.) The value required to achieve a desired flash rate can be
calculated as follows: To achieve a flash rate of 10 flashes per second on a 50 Hz AC power supply, for
example, the DIP value is 251. To select the blinder effect instead, set pin 9 to ON.
The optional remote control for ECS448 provides the following:
Intensity
Flash intensity is controlled from 20% of the maximum Intensity to 100% of the maximum Intensity with
the DIMMER fader.
The maximum intensity is reduced in low power mode, which is selected on pin 6 of the Mode DIP switch.
FAST
20%
BLACKOUT
FULL ON
SINGLE FLASH
SLOW
100%
SPEED
DIMMER
MODE
SOUND AUTO
CHASE
Fig.8
Summary of Contents for EXPLO3000D
Page 1: ...EN IT Manuale Utente User Manual EXPLO3000D DMX STROBE...
Page 17: ......
Page 35: ......
