ProLights CROMOBEAM260, User Manual

Page: 37 / 56

11
CROMOBEAM260
EDIT
Step 001 - 255
Pan
000 - 255
Tilt 000 - 255
Speed 000 - 255
Color
000 - 255
Gobo1 000 - 255
Gobo1 rot 000 - 255
Prism 000 - 255
Dimmer 000 - 255
Strobe
000 - 255
Time 000 - 255
Use No
Yes
DEFAULT Default
No
Yes
3.4 OPERATION IN AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows [INTRO] , then press the button ENTER.
• Select in submenu [RUN] , press ENTER button to confirm.
• Press the button UP/DOWN to switch between the programs ( DMX512 - AUTO1 - AUTO2 - SOUND1 - SOUND2 -
CUSTOM - TEST - SLAVE
). The unit will operate in automatic mode.
IMPORTANT: Programs AUTO1 - AUTO2 are fully pre-programmed and will not be altered by changes in EDIT
mode. Programs CUSTOM are fully pre-programmed and can be edited in EDIT mode.
NOTE - In automatic mode the unit will be set as Master.
3.5 EDIT CUSTOM PROGRAM
• Press the button MENU so many times until the display shows [EDIT] , then press the button ENTER.
• Select in submenu [EDIT] , press ENTER button to confirm the choice.
• Set the desired parameter value using the UP/DOWN buttons:
[STEP], [PAN], [TILT], [SPEED], [COLOR], [GOBO1],
[GOBO1 ROT], [PRISM], [DIMMER], [STROBE] and [TIME]. Press the ENTER button to confirm.
• Enter [USE] and select [YES] to run the steps user need.
CROMOBEAM260 will execute all the steps in the custom program and it will stop. To make the fixture to
start over add a last step whose duration is 0 second.