11
ARENACOB4HALO
Fixture Hours
This option shows the user the amount of hours the ARENACOB4HALO has been in use throughout its
lifetime. Select
Fixture Hours
.
Version
This option shows the user the software version currently installed in the unit. Select
Version
.
UID
This option shows the RDM identification number (see paragraph 3.23)
3.7 KEY LOCK
Enter the
Key Lock
mode to select whether the access password is on or off.
•
Press the MODE button so many times until show
Key Lock
and press the ENTER button to confirm.
•
Use UP/DOWN button to select:
ON
or
OFF
.
•
Press ENTER button to confirm the selection.
When the fixture is set as pass ON, after 30 seconds or turn on the fixture next time, the fixture will need
an access password to enter the display menu control.
NOTE - The factory access password is UP + DOWN + UP + DOWN (press ENTER to confirm the access).
3.8 AUTO SHOW
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
•
Press the MENU button so many times until the display shows Dynamic Patterns, then press the ENTER
button.
•
Press the UP/DOWN button to switch between the preprogrammed Dynamic Pattern. The unit will
operate in show mode.
•
Using the UP/DOWN button to select the desired run speed slow-fast 1-100.
•
Press the ENTER button to save the setting.
IMPORTANT: Dynamic patterns are fully pre-programmed and will not be altered by changes.
3.9 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
•
Press the MENU button so many times until the display shows Static, then press the ENTER button.
•
Select Fixed Color through the UP/DOWN buttons, then press ENTER.
•
Set the WHITE and AMBER color values through the UP/DOWN buttons, then press ENTER.
•
Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.10 MASTER/SLAVE MODE
This mode allows you to link up multiple units ARENACOB4HALO online without a controller. The first
unit will be set as the master and the others function as slaves with the same effect.
•
Press the MODE button so many times until the display shows [Master/Slave].
•
Press the ENTER button to confirm.
•
Press the UP/DOWN button and select [Slave] to set the drive as a slave.
Summary of Contents for ARENACOB4HALO
