ProLights ARCLED345, User Manual

Page: 18 / 28

ARCLED345
6
ARCLED345 allows several operating modes (fig. 4). By the 3 digits display the ARCLED345 shows the cur-
rent operating mode and the assigned value. By using the FUNCTION button and button it is
possible to set-up the following primary settings:
• MODE 1 (fig.4): press the FUNCTION button to change the cursor from A position to B position and C
position. Press the button to set the “0 - 9” values on the selected position.
• MODE 2: press the FUNCTION button in MODE 1. Press the button to set “00 - 63” values rela-
tive to Sub-ID address.
• MODE 3: press the FUNCTION button again from the MODE 2. Press the button to set “01 - 13”
values relative to the desired internal programs.
• MODE 4: press the FUNCTION button again from the MODE 3. Press the button to set “01 - 04”
values relative to the parameters of internal programs.
• MODE 5: press the FUNCTION button again from the MODE 4. Press the button to set “00” for
SLAVE mode or “01” for MASTER mode.
Please note: for an easy access setting, by holding for 5 seconds the FUNCTION button is possible to:
• return to MODE 1 from MODE 1 or MODE 2;
• return to MODE 3 from MODE 3, MODE 4 or MODE 5.
3.1 Operation
Connect the supplied main cable to a socket (230 V~/50 Hz). Then the unit is ready for operation and can be
operated via a DMX controller or independently displays its show programme in succession. To switch off,
disconnect the main plug from the socket. For a more convenient operation it is recommend to connect the
unit to a socket which can be switched on and off via a light switch.
3.2 Set-up
• If the unit receives a DMX signal a small dot will flash on C position (fig.3);
• When the unit receives a signal from a master unit, a small dot will flash on B position;
• If the master unit send a signal to slave unit, a small dot will flash on A position.
- 3 - FUNCTIONS AND SETTINGS
Fig.3
A B C
Fig.4
Mode Definition
LED Display (Fig.3)
A B C D
1 DMX Address Setting 001-512
2 ID Address Setting d 00 - 63
3 Build-in Programs A 01 - 13
4 Speed of Build-in Programs Adjustable E 01 - 04
5 Master Mode Setting H 00 - 01