17
AIR5FAN
Reload DEFAULT
Select this function to reset the unit to factory settings:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
Advanced
icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Factory Reload
and press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to select
YES
or
NO
, then press the ENTER button to confirm.
3.14 FIXTURE INFORMATION
To view all the information on the device, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the icon Information, then press the ENTER but-
ton to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
-
Time Information
- Through the Time Information function you can display the operating time of the
projector.
-
Temperature
- Through the Temperature function can be displayed the temperature inside the fix-
ture, near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
-
Fans Speed
- Through the Fans Speed function you can show on display the fan speed present near
the lamp. Velocity is expressed in RPM (revolutions per minute).
-
Channel Value
- Channel Value function can be used to display the values of the channels by which
the unit will operate when switched on.
-
Error Message
- Through the Error Message function can be displayed any errors channels.
-
Fixture Model
- Through the Fixture Model function can be displayed the model number and manu-
facturer.
-
Software Version
- Through Software Version function you can display the currently installed software
version.
• Press the LEFT button repeatedly to exit the menu.
3.15 OPERATIONS IN AUTOMATIC MODE
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
Stand Alone
icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Play
and press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Sequence
and press ENTER to confirm
your choice.
• Press the UP/DOWN button to select the mode of operation:
-
Master
, if the unit is connected in series with other units and it acts as the Master;
-
Alone
, if the unit is not connected to other units.
• Press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
The unit will go into automatic mode by executing the program automatically.
