Prolights Tribe PHYRO1000D, User Manual

Page: 20 / 28

PHYRO1000D 6
2.2 BASIC
1. Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3. Pour the Prolights liquid in the tank without exceeding the maximum level to prevent overflow. Col-
lect immediately with a dry cloth to prevent that any liquid enters into the machine. The unit is not
protected against splashing water. If liquid does get inside, do not operate the machine, but refer for a
control, to the nearest authorized service center.
4. The machine only works with Prolights liquid SMOKEFLUID series. Any other types of fluid can damage
the unit. During the filling operation, the machine must not be connected to the electricity grid. First
disconnect the plug from the socket.
5. Always replace the tank. Check that the suction hose reaches the bottom of the tank.
AVOID THE UNIT REMAINS WITHOUT THE FOG LIQUID: THE PUMP COULD BE DAMAGED.
NOTE
• All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when in-
stalling your unit.
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or
so after being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
- 2 - FUNCTIONS AND SETTINGS
2.1 CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LED Display
(fig.2).
Fig.2 - Functions of the buttons
Mode Up
Down Enter
MENU UP DOWN ENTER
Used to scroll through the
main menu Navigates upwards through
the menu list and to increases
the numeric value when in a
function Navigates downwards
through the menu list and to
decreases the numeric value
when in a function Used to enter the current
function or confirm the
current function value