7)
When finished press the “Mode” and “Fine” buttons at the same time again
to exit Assign mode.
SCENES
l
Programming A Scene
1)
Enter program mode (See Enabling Program Mode)..
2)
Check the blackout key and verify that the LED is not lit, if it is, press it
once to exit blackoutmode.
3)
Verify that the speed and fade time sliders are positioned at zero.
4)
Press the scanner button corresponding to the unit wish to control. You may
control more than one scanner at time by pressing the button corresponding
to the scanner(s) you wish to program.
5)
Move the faders and joystick to the desired position. If necessary, you may
select page B to control channels 9-16.
6)
Tap the bank Up/Down button to choose the bank you want to store this
scene into. There are a total of 30 banks you can select, you may store up to
8 scenes in each bank.
7)
Once all scanners are programmed into the desired position for the scene,
tap the Rec button to program this scene into memory.
8)
Tap the scene button you wish to store your scene into. All LEDs will flash
three times signifying this operation. The LCD readout will show the bank
and scene.
9)
To unselect the scanner(s) you have been programming and switch to
another simply press the button of the scanner you have been programming
again, deselecting it, and select another scanner.
10)
Repeat steps 2-7 until all scenes have been programmed.
11)
If you don’t intend to continue programming at this time, press and hold the
program button for three seconds to exit program mode. The LED will go
out indicating this selection.
l
Example Scene Program
1)
Program Enable.
2)
Tap the Scanner 1 button to turn on its fader control.
3)
Verify that the page select is set on page A, if not press the page select
button to select page A.
4)
Move the first and second faders all the way up to their maximum value
position.
5)
Select bank 1 using the bank Up/Down buttons.
6)
Press the Rec button.
7)
Tap scene 1 to store the first scene.
8)
Repeat steps 4-7 until all scenes have been programmed into bank 1.
9)
Tap the scanner 1 button to turn off the fader control.
10)
When finished, disable program mode. You can now manually tap through
you have just programmed.
l
Editing A Scene
1)
Program Enable.
2)
Press the Bank Up/Down button to select the bank containing the scene you
wish to edit.
3)
Select the scene you wish to edit by tapping it’s scene button.
4)
Use the faders and/or joystick to make the desired adjustments to the scene.
5)
Once you have completed the changes, tap the Rec button.
6)
Tap the scene button that corresponds to the scene you’re editing. This will
override the existing scene.
Be sure to select the same scene in steps 3 and 6, otherwise you may
accidentally record over an existing scene.
l
Copy Scanner Settings –
This setting allows you to copy the settings of one
scanner to another
1)
Press and hold down the scanner button you wish to copy.
2)
While holding down the button, tap the button of the scanner you wish to
copy the settings to.
l
Copy A Scene
1)
Enable Program Mode.
2)
Tap the Bank Up/Down button to select the bank containing the scene you
wish to copy.
3)
Select the scene you wish to copy by pressing it’s scene button.
4)
Using the BankUp/Down button select the bank you wish to copy the scene
to.
5)
Tap the Rec button.
6)
Tap the scene button you wish to copy the scene to.
l
Deleting A Scene
1)
Enable Programming Mode.
Summary of Contents for TRANSCENSION DMX OPERATOR 2
Page 9: ......
