6A
Led Display
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to select the
(Led on) or
(Led off) mode. Once the mode has been selected, press the
ENTER
button to setup or automatically return to the main functions without any change after 8
seconds. To go back to the functions without any change press the
MENU
button again.
Display Inversion
It is good for you to install the unit on the floor or under ceiling. Press the
MENU
button up to
when the
is blinking on the display. Use the
ENTER
button to change to the mode
(display normal), It will automatically store after 8 seconds. Or press the
ENTER
button again return to the mode
(display inversion). To go back to the functions
press the
MENU
button.
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Temperature Test
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the temperature of the unit. To go back to the functions
press the
MENU
button again.
Fixture Hours
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the number of working hours of the unit. To go back to the
functions press the
MENU
button again.
Software version
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the version of software of the unit. To go back to the
functions press the
MENU
button again.
7A
4.2 DMX Address Setting
A. Automatic DMX-addressing
1.
The DMX address of fixture can be set automatically. You have to press the
button from the first fixture and hold for 5secs, the DMX start address of it will be set to
1, and the other fixtures of the chain will be set their own DMX start address
automatically.
2.
The LED fixtures use four channels, the next fixture’s will be automatic calculate their
own DMX address, not need to calculate the DMX channels of each fixture in the chain.
(Fixture 1 = 1, Fixture 2 = 5, Fixture 3 = 9, Fixture 4 = 13, Fixture
…
)
3.
No need to turn the fixture off when you change the DMX address, as new DMX
address setting will be effect at once. Every time you turn the fixture on, it will be ready
to receive DMX signal or run the built-in programs.
B. Remote DMX address setting by CA-T DMX TESTER
The fixture can be set the DMX address remotely by CA-T DMX TESTER. Please refer to
the CA-T user manual to set the DMX address to the fixture.
5. How to control the fixture
There are three ways to control the fixture
A. Universal DMX controller
B. Master/Slave operation
C. Easy controller (by CA-8)
