- 73 -
The LED display will flash the set timer three times and then turn back to show the current humidity. The
timer has been set.
Once the timer is set, the LED display will show the current humidity, the mist output level and the timer
and then repeat circularly.
Note:
You can also long touch the button “TIMER” for 2 seconds to cancel the timer function during
working.
7.
Touch the button “HUMIDITY” to set your expected humidity from 30%RH to 90%RH. Touch once; it will
increase by 5%RH. (Touch the button till the LED display shows “Co”. It means to cancel the humidity
setting.)
The LED display will flash the expected humidity three times and then turn back to show the current
humidity. The appliance enters into the constant humidity function.
Under constant humidity function, the mist output level is nonadjustable. The appliance will adjust it
automatically.
-
When the expected humidity is 16%RH higher than the current humidity, the appliance works in mist
output level 3.
-
When the expected humidity is 10%RH - 15%RH higher than the current humidity, the appliance works
in mist output level 2.
-
When the expected humidity is 1%RH - 9%RH higher than the current humidity, the appliance works in
level 1.
-
When the expected humidity is less than the current humidity, the appliance will be in sleeping state.
Once the expected humidity is set, the LED display will show the current humidity, the expected humidity
(slow twinkle) and the timer (if set) and then repeat circularly.
Note:
During working, long touch the button “HUMIDITY” for 2 seconds, the appliance enters into the night
mode. The indicator light in the bottom of the unit will be off as well as the LED display. Long press again to
exit the night mode.
Auto shut-off function
Once the water in the basin is too little to keep the humidifier working, the humidifier will automatically stop
working. The indicator light in the bottom of the unit will turn red. Refill the water tank, and touch the on/off
button again to restart. The red light will change to blue color.
MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
“white powder (limestone)” problem and may cause heavy sediments on the surface of the water basin,
transducer and inner surface of the water tank. Sediments on the surface of the transducer could influence
proper function.
We recommend:
1)
Use cold boiled water or distilled water.
2)
Clean the transducer, water tank and basin unit every week.
3)
Change water in water tank frequently to avoid “white powder” / limestone.
4)
Make sure to drain water out from the water tank and dry the water basin before storing the unit for a long
period of time.
5)
Clean the whole unit, and make sure that all parts of the unit are dried completely before use.
When there is leakage from the bottom of the tank, from the part where the spring is, please press and
release the spring a couple of times to remove calcareous residue which can cause the leakage.
Summary of Contents for HF-106631.2
