WARNING: During the Reset Procedure, the table lift will retract 7mm below the lowest normal operating height,
please ensure that no obstacles impede this motion of travel.
1.
M
ove the table lift to the lowest position.
(
If there is an
'RSt'
displayed on the remote,
continue
to
step
3
.
)
2.
To initiate the Reset Procedure, press and hold the down button on the remote until "ASr" is
displayed. Release the down button.
3.
Press and hold the down button on the remote, the table lift will begin to retract 7mm lower
than
the
lowest normal operating height. To stop motion at any time, let go of the down button.
4.
Once the table lift has completed the Reset Procedure, height will be displayed on the
remote.
Normal Operation
Using the wired remote, press and hold the
'U
p
'
button to raise the table lift. To lower the table lift, press and hold
the
'D
own
'
button. The
'U
p
'
and
'D
own
'
buttons are momentary controlled,
when they are released, the table lift will
stop immediately.
To set a preset location, move the table lift to the desired height. Press the 'M' button followed by a numbered
button. The
LED
display
will flash a
n
'S',
followed by an
'S - Number'. This will indicate that the preset has been saved.
To use a preset, press any of the numbered buttons and the table lift will begin to move to the preset
position
. It is
important to ensure that no obstacles impede the motion of travel. To stop the table lift, press any button.
If the table lift does not function as intended or the LED display flashes
"
RSt
"
, please follow the Reset Procedure
outlined in the next section.
Using the wired
smart
remote, retract the table lift to the lowest position. Press and
hold the 'Down' button again until the LED display flashes "RST".
Press and hold the 'M' button until the LED display flashes the starting height (if
the display returns to "RSt" before the next step, repeat this step).
To change the value of the starting height, use the 'Up', 'Down' to increase and
decrease by 0.1. Use the '1', '2' to increase and decrease by 1s. Use the '3', and '4'
buttons to increase or decrease by 10s.
Once the correct value is displayed, wait 5 seconds until the LED display flashes
"RSt". Follow the Reset Procedure outlined in the next section to save the new
starting height.
Note: the LED display has a tolerance of ±0.1.
Setting the LED Display
Reset Procedure
Operation
7
