Problem and alarm code
Possible cause and solution
Small leak from the appliance door.
• The appliance is not level. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Ad-
just the rear foot (if applicable).
The appliance door is difficult to close.
• The appliance is not level. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the
baskets.
Rattling/knocking sounds from inside
the appliance.
• The tableware is not properly arranged in the
baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-beaker.
• The amperage is insufficient to supply simultane-
ously all the appliances in use. Check the socket
amperage and the capacity of the meter or turn
off one of the appliances in use.
• Internal electrical fault of the appliance. Contact
an Authorised Service Centre.
Refer to
"Before first use"
,
"Daily use"
, or
"Hints and
tips"
for other possible causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
Possible cause and solution
Poor washing results.
• Refer to
"Daily use"
,
"Hints and tips"
and basket load-
ing leaflet.
• Use more intensive washing programs.
Poor drying results.
• Tableware has been left for too long inside a closed appli-
ance.
• There is no rinse aid or the dosage of rinse aid is not
enough. Set the rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
There are whitish streaks or
bluish layers on glasses and
dishes.
• The release quantity of rinse aid is too much. Adjust the
rinse aid selector to a lower position.
• The quantity of detergent is too much.
There are stains and dry water
drops on glasses and dishes.
• The released quantity of rinse aid is not sufficient. Adjust
the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
Progress
15
