Installing the door and the glass panel
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of
the door. Make sure that after the installa-
tion the surface of the glass panel frame on
the screen-printing zones is not rough
when you touch it.
Make sure that you install the middle panel
of glass in the seats correctly (refer to the il-
lustration).
WHAT TO DO IF…
Warning!
Refer to "Safety information"
chapter.
Problem
Possible cause
Remedy
The oven does not heat up.
The appliance is deactivated.
Activate the appliance.
The oven does not heat up.
The clock is not set.
Set the clock.
The oven does not heat up.
The necessary settings are not
set.
Make sure that the settings are
correct.
The oven does not heat up.
The automatic switch-off is on.
Refer to "Automatic switch-off".
The oven does not heat up.
The Child Lock is on.
Refer to "Deactivating the Child
Lock".
The oven does not heat up.
The fuse in the fuse box is re-
leased.
Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.
The oven lamp does not op-
erate.
The oven lamp is defective.
Replace the oven lamp.
The oven does not heat up.
The fan does not operate.
The display shows
or
.
The demo mode is activated.
1. Deactivate the appliance.
2. Press and hold the button
for approximately two sec-
onds. An acoustic signal
sounds.
3. Press and hold the buttons
and
at the same time until
the acoustic signal sounds
again and the indicator goes
out.
The display shows an error
code that is not on this list.
There is an electronic fault.
1. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and acti-
vate it again.
2. If the display shows the error
code again, contact the serv-
ice centre.
progress
37