Ego 24
7.3
Push handles for attendant
You can assemble these push handles only on a “sport”
backrest tubes that have with no handles.
You can height adjust them in order to offer a better
handhold and a better pushing position to the attendant.
The attendant and/or the user can easily adjust them
and remove them.
To adjust them in height, unscrew the lever L, slide the
tube up or down to the desired height, position the
handle backward and finally screw the lever L tightly.
To remove the push handle, unscrew the lever L and
slide the tube off the support.
To put on the push handle, insert it and let it go through
the support and adjust its height as above mentioned.
Important warning for the attendant: the push handle tubes are safe only when the
two lever L are tightly screwed, in fact, this condition prevent the tubes from sliding up
or down accidentally.
Before pushing the wheelchair, make sure the two tubes are safely locked.
Rehateam s.r.l. cannot be responsible for any damage or injury due to neglecting this
warning.
7.4
Tipping aid
This accessory has been designed to enable the assistant to tip back the wheelchair without a great
effort in order to go over small steps easily. With one foot, press down on the plastic support while,
at the same time, applying downward force onto the push handles.
You can remove the tipping aid by pressing the pin A that hold it in positon and sliding the tube
from the support S.
To insert the tipping aid, slide the tube in the support S until the pin A touches the support.
Then, press the pin and let the tube in until the pin locks through the hole of the support.
L
L
S
A
