REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual CARBOMAX 17
SERVICE MANUAL
TUBULAR ALUMINIUM FOOTPLATE
Both for tubes with hole and for sliding system
B
B
D C
B
B
B
E
Angle adjustment.
You can adjustment the inclination by changing the leaning point of the footplate.
Flip the plate back.
On the horizontal part of the footplate tubes there is threaded rivet that works as leaning
point
B
.
A bolt
C
and the washer
D
is usually present on this point.
Therefore, you can adjust the inclination by increasing or decreasing the thickness over the
rivet.
To increase the inclination, remove the bolt
C
and add other washers
D
or a suitable spacer.
Finally, insert and tighten the bolt
C
.
To reduce the inclination, remove the bolt
C
and remove the necessary washers/spacers.
Finally, insert and tighten the bolt
C
.
Without the bolt
C,
you can reach the minimum inclination.
To eliminate the possible noice due to the contact between the plate and its leaning point,
you can simply stick rubber or similar pad under the plate where necessary.
Footplate position
Only internal.
Adjustment of flip-back movement
When you loosen the two bolts
E
, the movement becomes easier.
When you tighten the two bolts
E
, the movements becomes harder.
If you tighten the two bolts very hard, the movement is almost stuck.
Note: you can also fix the plate if you drill two holes aligned to the leaning points
B
and fix it
with the two bolts
C
.
At each adjustment, it is advisable to spread a
drop of mild lock thread glue on the bolts
C
.
