18
STEP 7
7A Support Frame Handlebar Installation:
As you begin to mount the
Hand Pulse Handlebar
Support Frame (41)
to the
Mainframe (59)
, insert the
Tension Cable (79)
through the bottom
opening in the shaft of the
Hand Pulse Handlebar Support Frame (41)
and pull it out through the
shaft opening located midway up the support frame. See
Figure B
.
7B
Installing The Hand Pulse Handlebar Support Frame:
Fully mount the
Hand Pulse
Handlebar Support Frame (41)
to the
Mainframe (59)
. After being mounted, secure the
Hand
Pulse Handlebar Support Frame (41)
onto the
Mainframe (59)
with four
Bolts (47)
, four
Spring
Washers (36)
, and four
Washers (24)
. Use the
6mm Allen Wrench with Phillips Screwdriver
to
tighten the
Bolts (47)
until they are firm and secure.
7C
Installing The Sensor Wires To The Mainframe:
Connect the
Sensor Wire (78)
attached to
the
Mainframe (59)
to the
Extension Sensor Wire (10)
coming from the bottom end of the
Hand
Pulse Handlebar Support Frame (41)
. Make sure the co
nnectors “click” when connected. See
Figure C
.
Multi Hex Tool with Phillips
Screwdriver
TOOLS
6mm Allen Wrench with
Phillips Screwdriver
ASSEMBLY
Figure B
Figure C
(47) Bolt
4PCS
(24) Washer
4PCS
(36) Spring Washer
4PCS
HARDWARE PACK
Summary of Contents for Air Elliptical 1307
Page 5: ...3 LABEL PLACEMENT...
Page 8: ...6 OVERVIEW DRAWING...
Page 11: ...9 HARDWARE TOOLS PACK...