5
Industrial Fan Forced Heater
Your heater is equipped with a thermostat:
1. Turn the unit on by turning the thermostat dial away from the OFF position (
).
2. Once the room reaches the desired temperature, slowly turn the Thermostat Control knob counter
clockwise until you hear a "click". This sets the heater to cycle ONIOFF to maintain the desired
heating temperature for energy efficiency.
3. To completely shut unit OFF, turn the thermostat dial to the OFF position (
) and unplug the heater.
Parts of the Heater
1. Carry handle
2. Housing
3. Safety grille
4. Heating element
5. Thermostat control
6. Plug (NEMA #6-30P)
Grounding and Operating Instructions
IMPORTANT: THIS HEATER IS FOR USE ON THE FLOOR ONLY.
Prior to operating the heater, ensure the electrical receptacle is of the configuration and capacity
appropriate for the heater. See receptacle configuration in OPERATING INSTRUCTIONS. This heater is for
use on 240 volts. The cord has a plug as shown in #6. No adapter is available for this blade configuration,
and none should be used. The type of receptacle is a 240 volt grounding receptacle (NEMA 6-30R). When
properly installed, it provides a ground connection through the cord to the heater to protect the operator
from electric shock.
Receptacle: NEMA #6-30R 250V 30 Amps
Plug: NEMA #6-30P 250V 30 Amps
1
2
3
4
5
6
