3
Industrial Fan Forced Heater
Important Instructions
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO
REDUCE RISK OF FIRE, ELECTRICAL SHOCK AND INJURY TO PERSONS OR PROPERTY, INCLUDING THE
FOLLOWING:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 ft.
(0.9 meters) from the front and top of the heater and keep them away from the sides and rear. Ensure
a minimum clearance of 5.5 inches (14 cm) from both sides and rear of heater to adjacent walls. Keep
the rear grille away from walls or drapes so as not to block the air intake.
3. Extreme caution and reasonable supervision is necessary when any heater is used by or near children,
invalids or pets and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use. To disconnect, grip plug and pull from wall outlet. Never yank
on cord.
5. To disconnect the heater, turn controls to "OFF" (
), then remove the plug from outlet.
6. Do not operate any heater with a damaged cord or plug or after the heater malfunctions or has been
dropped or damaged in any manner. Return heater to an authorized service facility for examination,
electrical or mechanical adjustment or repair.
7. Do not use outdoors.
8. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or other water container.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Do not route
cord under furniture or appliances. Arrange cord away from traffic area where it will not be tripped
over. Route the cord so that it will not be walked on, or pinched by furniture.
10. Connect to properly grounding outlets only. Check heater voltage and amperage on the back of the
heater to make sure it agrees with the electric service supplied.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock, fire or damage to the heater.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked.
13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, injury to persons or other damage to property.
14. This heater draws 23.3 Amps during operation. Be sure to use a dedicated 240VAC, 30A circuit for the
heater.
PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER.
NOTE: There may be a trace of smoke or odor when unit is first operated. Do not be alarmed. This indicates
that a drop of oil fell on the heating coil during the manufacturing process. It will quickly evaporate and
should not re-occur.
Make sure that the room in which the appliance is located is well ventilated during this operation. It is normal
for the appliance to emit small cracking sounds when you turn it on for the first time. Do not be alarmed.
