Air
R
emo
te TTL
-O
/P
12
www.profoto.com
Power on/off
1. Press and hold down the ON button [1] to switch on/off the remote.
Note!
The remote automatically turns off after 30 minutes of inactivity. The auto power off can be deactivated by
pressing and holding the “” button [3] when starting the remote. Deactivation is confirmed by two short
beeps.
Note that when auto power off is deactivated new batteries will drain in approximately 20 hours of inactive use.
The camera should not be in a silent drive mode.
Channel selection
The currently selected channel is shown in the CHANNEL section on
the Display [2].
1. Press the Channel button [8] repeatedly until the desired channel
is displayed.
Sync selection
The selected sync setting (cameras sync setting) is shown in the SYNC
section on the Display [2].
Press the Sync button [7] to cycle through the sync options:
• 1st: The flashes fire when the first shutter curtain is fully open.
• 2nd: The flashes fire when the second shutter curtain is about to
close.
• Hi-S: HSS is selected.
NOTE:
In TTL mode, the camera selects SYNC status. In MAN mode, the user can toggle the HSS setting with the SYNC
button. If the camera is in a mode where HSS can’t be used, the remote will switch off HSS automatically.
HSS (FP flash)
HSS enables shooting with flash at a faster shutter speed than the
fastest external flash sync speed (x-sync) of the camera, all the way
down to 1/8000s (may differ between camera models). This option
can be extremely useful to limit the influence of ambient light when
shooting in bright conditions.
