AIr Remote TTL-N
10
www.profoto.com
operating instructions
Quick guide
For detailed instructions, refer to the subsequent sections.
Profoto flash setups
1. Set the flash to synchronization via Radio/Air (may differ by generator).
2. Select the same radio channel on all flashes.
3. Select the same group (A, B or C) for all lamp heads to be controlled simultaneously.
Air remote TTL-N
4. Slide the hot shoe connector on the Air Remote TTL-N into the hot shoe of the camera.
Turn the Locking mechanism [13] to secure the device.
5. Switch on the device.
6. Select the same radio channel as on the generators.
7. Press the Mode button [6] to toggle between TTL (Automatic) and MAN (Manual) mode.
8. Press the A, B or C button to select the corresponding group.
9. When a group is selected:
a) Press the HEAD button [8] to turn on/off the lamp heads.
b) Press the MODEL [9] button to turn on/off the modeling light.
c) Press the ENERGY buttons [3] to adjust the energy level for the group in relation to
the other groups (TTL mode) or the energy level for the group (MAN mode).
10. Press the TEST button [5] to manually transmit a sync signal, in order to test the
settings.
Power on/off
1. Press and hold down the ON button [1] to switch on/off the remote.
Channel selection
The currently selected channel is shown in the CHANNEL section on the Display [2].
1. Press the Channel button [7] repeatedly until the desired channel is displayed.
