www.profort.com
ver. 3.01
climaSpot
Monitoring of temperature and humidity
Function:
climaSpot is a wireless detector with 1 built-in temperature probe and 1 built-
in probe for measuring humidity. climaSpot is applied exclusively to monitor
temperature and humidity. Every 4 minute climaSpot sends the actual
temperature and humidity, and these data will be logged in the central unit.
climaSpot is supplied by a 3V lithium battery.
NB! climaSpot doesn’t give a general alarm or sabotage. But climaSpot sends
an alarm in case of low battery power.
Assembly:
climaSpot is placed in the room or showcase where it schould measure the
temperature. climaSpot must be placed as high as possible. Preferably in a
way that the antenna is not “hidden” behind metal or reinforced concrete.
This considerably limits the reach of the antenna.
climaSpot is installed by means of a screw going the whole way through the
oval hole or by means of double-sided tape.
NB! The sensor is placed just below the oval hole, therefore be careful when
mounting the detector.
Service and maintenance:
Every 6 months a check must be made to see if climaSpot’s transmission
conditions are optimal. This is done in the supervision facility of the central
unit by checking the amount of signals sent by climaSpot, and the GSM signal
strength. The GSM signal strength must not be less than 25%.
If the signal strength is less than 25% the physical conditions having an
impact on the signal strength must be regulated. Simultaniously it must be
checked that the central unit monitors the battery supply, so that the system
receives a warning in case that the battery is about to expire.
To see if climaSpot functions it is necessary to check that the signals per
minute of measuring are actually logged in the system. This must be done if
there is any suspicion of transmission failure. Be aware that climaSpot has to
be registered as “surveilled” in the system in order for the system to give a
battery warning.
If climaSpot doesn’t function the battery must be changed. If this doesn’t
help, replace the entire detector.
The battery is changed by loosening the 2 screws at the back of climaSpot. The
battery is loosened carefully using the fingers. Hereafter insert a new battery.
Be aware that the battery must be placed in a way that it is not squeezed when
the cover is installed. The battery must be turned with the +pol towards the
battery clips.
Take care that the antenna is not damaged.
Notice:
If the surroundings around climaSpot are suddenly changed, for
instance if the detector is moved or if a door opens, approx. 10 min. must pass
before the measuring result is reliable because the sensors need to calm.
Specifications:
Dimensions:
79x39x9mm
Weight incl. battery: 25 g
Power supply:
Lithium 3V
Battery life time:
max. 3 years
Temparature:
÷10° - +55°C
climaSpot comes in two 2 versions (004860 008320), using different sensors:
004860 climaSpot:
008320 climaSpot:
