ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own phillips screw-
driver and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (69) to a vertical position.
Insert a Handrail Extension (66) into the post on the right
Upright (69) as shown; make sure that the indicated holes
are on top. Tap the Handrail Extension with a rubber mallet
to fully insert it. Attach the Handrail Extension with two 3/4”
Screws (67) as shown.
Identify the Right Foam Grip (75), which has a large cutout
in the left side for the Pulse Bar (76). Slide the Right Foam
Grip as far as possible onto the post on the right Upright
(69). (Note: It may be helpful to apply soapy water to the
Handrail Extension [66].) Make sure that the tab on the
Foam Grip is inserted into the Console Base (81).
75
Cutout
66
Post
Holes
69
81
1
6
2. Make sure that the edge of the Right Foam Grip (75) is
under the Console Base (81) as shown. Tighten a 3/4”
Screw (67) into the side of the Right Foam Grip as shown.
Note: It may be necessary to pull the Foam Grip out
slightly (see arrow A) to align the Screw with the hole in
the post.
Attach the other Handrail Extension (not shown) and the
Left Foam Grip (not shown) as described in step 1 and
this step.
75
67
A
81
2
3. Attach the Latch Assembly (11) and the Latch Spacer
(71) to the Left Foam Grip (65) with the two Latch Screws
(70) as shown. Note: Tighten the Latch Screw indi-
cated first.
11
First
71
65
70
3
Tab
67
76
67
67
70
