17
40. Locate the Low Cable (82). Route the eyelet
end of the Cable through the Center Upright (37)
and under a 90mm Pulley (90). Attach the Pulley
inside the Upright with an M10 x 75mm Bolt
(127), two M10 Washers (99), two 17mm Spacers
(86), and an M10 Nylon Locknut (97).
41. Route the Low Cable (82) over a 90mm Pulley
(90) as shown. Attach the Pulley and two Half
Finger Guards (133) to the Double “U”-bracket
(73) with an M10 x 47mm Bolt (136) and an M10
Nylon Locknut (97).
42. Route the Low Cable (82) under a 90mm Pulley
(90) as shown. Attach the Pulley and two Half
Finger Guards (133) to the Rear Base (33) with
an M10 x 47mm Bolt (136) and an M10 Nylon
Locknut (97).
43. Route the Low Cable (82) over a 90mm Pulley
(90) as shown. Attach the Pulley, a Small Cable
Trap (125), and two Half Finger Guards (133) to
the second set of holes from the bottom of the
two Pulley Plates (72) with an M10 x 47mm Bolt
(136) and an M10 Nylon Locknut (97). Make sure
the Cable Trap is oriented to hold the Cable in
the groove of the Pulley.
40
82
37
97 99
99
127
90
86
86
97
73
136
133
133
90
82
41
97
90
82
33
97
90
125
82
72
136
133
133
42
43
24. Attach the Center Upright (37) to the Center Base
(32) and Rear Base (33) with an M10 x 78mm
Bolt (110), an M10 Washer (99), and an M10
Nylon Locknut (97). Do not tighten the Locknut
yet.
Attach the Center Upright (37) to the Center Base
(32) with an M10 x 75mm Bolt (127), two M10
Washers (99), and an M10 Nylon Locknut (97).
Do not tighten the Locknut yet.
Attach a Weight Carriage Stop (70) to the Rear
Upright (38), at the indicated hole, with an M10 x
88mm Bolt (114) and an M10 Nylon Locknut (97).
Make sure the Square Carriage Bushing (61)
is on top.
Attach the Rear Upright (38), with the hexagonal
holes on the indicated side, to the Rear Base (33)
with two M10 x 75mm Bolts (127), four M10
Washers (99), and two M10 Nylon Locknuts (97).
Do not tighten the Locknuts yet.
12
Hexagonal
Holes
24
110
37
38
97
97
33
32
99
99
127
114
61
127
Hole
99
99
70
97
97
55
59
120
23. Slide the Barbell Adapter (59) onto the Weight
Bar (55). Thread a 1/4” x 9.5mm Allen Head Set
Screw (120) into the Barbell Adapter. Do not
tighten the Screw yet.
Repeat this step with the other Barbell
Adapter (not shown).
23
136
133
133
