6
2. While another person lifts the back of the Frame (1),
attach the Rear Stabiliser (16) to the Frame with four
M8 x 70mm Button Screws (68).
68
68
1
3
2
31
41
20
43
42
1
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (42) to
the Lower Wire Harness (43). Gently pull the upper end
of the Upper Wire Harness to remove any slack from
the Wire Harnesses.
Turn the indicated Adjustment Knob (20) counterclock-
wise two or three turns to loosen it. Next, pull the Knob,
insert the Upright (2) into the Frame (1), and then
release the Knob.
Be careful to avoid pinching the
Wire Harnesses (42, 43). Move the Upright up and
down slightly until the pin on the Knob snaps into
one of the holes in the Upright.
Then, turn the Knob
clockwise until it is tight.
Attach the Water Bottle Holder (31) to the Upright (2)
with two M4 x 12mm Screws (41).
16
Make sure the
Wire Harnesses
(42, 43) do not
get pinched and
damaged during
this step.
4. Slide the two Handlebar Collars (73) onto the Left
Handlebar (3). Insert the ends of the Right Handlebar
(5) into the Left Handlebar. Connect the Handlebar
Collars, the Left Handlebar, and the Right Handlebar
with two M4 x 16mm Screws (57).
Attach the Handlebar Bracket (6) to the Left and Right
Handlebars (3, 5) with four M8 x 22mm Button Screws
(59).
59
59
3
5
6
57
57
73
73
4
2
