10
13
13. Plug the Reed Switch (80) into the
Transmitter (81).
Insert the other end of the Reed Switch (80) into
the Clamp (82).
Rotate the Flywheel (36) until the Magnet (84) is
aligned with the end of the Reed Switch (80).
Move the Reed Switch (80) so that the gap
between the Reed Switch and the Magnet (84) is
about 1/8 in. (3 mm).
36
84
82
81
14.
Make sure that all parts are properly tightened before you use the exercise bike. After the exercise
bike is assembled, inspect it to make sure that it is assembled correctly and that it functions properly.
Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise bike
to protect the floor.
80
HOW TO USE THE EXERCISE BIKE
HOW TO ADJUST THE ANGLE OF THE SEAT
You can adjust the angle of the seat to the position that
is most comfortable. You can also slide the seat for-
ward or backward to increase your comfort or to adjust
the distance to the handlebar.
To adjust the seat, see the drawing in assembly step
7 on page 7. Loosen the nuts on the seat clamp a few
turns, and then tilt the seat upward or downward or
slide the seat forward or backward to the desired posi-
tion. Then, retighten the nuts.
HOW TO ADJUST THE HORIZONTAL POSITION OF
THE SEAT
To adjust the hori-
zontal position of
the seat, first loosen
the adjustment knob
and pull it down-
ward. Then, move
the seat forward or
backward, release
the adjustment knob
into an adjustment
hole in the seat carriage, and firmly tighten the adjust-
ment knob.
Make sure that the adjustment knob is
engaged in an adjustment hole.
Seat
Adjustment
Knob
