11
If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove the indicated #8 x 1/2" Screw (1) and
the Access Door (87) from the Console Base
(93).
2. Connect the wire on the receiver to the indi-
cated wire extending from the Console Base
(93).
Hold the receiver so the antenna is ori-
ented as shown and is facing the Console
Base.
Attach the receiver to the plastic posts on
the Access Door (87) with the two included
small screws.
3.
Make sure that no wires are pinched.
Reattach the Access Door (87) with the #8 x
1/2" Screw (1). Discard the other wires included
with the receiver.
Receiver
87
Antenna
1
93
Wires
Small
Screws
12. Raise the Frame (56) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (53) so that the large
barrel and the Latch Knob (54) are in the posi-
tions shown. Attach the lower end of the Storage
Latch to the bracket on the Base (83) with a 3/8"
x 2" Bolt (4) and a 3/8" Nut (8).
Attach the upper end of the Storage Latch (53)
to the bracket on the Frame (56) with a 3/8" x 2"
Bolt (4) and a 3/8" Nut (8). Note: It may be nec-
essary to move the Frame back and forth to
align the Storage Latch with the bracket.
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 20).
53
8
8
Large
Barrel
83
4
56
12
4
54
13.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see pages 22 and 23).
